Solution: JShip key not working

You should feel and hear a distinct “click” when pressing the keys of your JShip parcel scale.
JShip-130 indicator

If that’s not the case or if you have to use excessive force, please do not try to use a sharp object as this might puncture the overlay. Instead, return your scale for repair or try repairing it yourself as described below.

We found that – in most cases – the buttons themselves are working fine and all you have to do is tighten the screws holding the PCB inside the indicator.

Please note that these are not official instructions and we do not accept any responsibility if things go wrong.

1. Open indicator housing

Remove all six screws on the back of the indicator. Note how they’re tightened very lightly. Remove plastic cover.
Open JShip-130 indicator

2. Tighten screws on PCB

There are 5 screws holding the PCB in place. Use a PH1 or PH2 screwdriver to tighten them as much as possible without over-tightening. If all screws are already firmly tightened, try carefully turning just the two screws marked below clockwise by no more than 1/8 of a turn.
Inside JShip-130 indicator

Press the keys to see if the problem has been resolved.

3. Close indicator housing

Put the plastic cover back in place and very lightly tighten the six screws. If you turn them too far, the rather brittle cover might break.